Introduction to the manual
What this chapter contains
The chapter describes applicability, the target audience and purpose of this manual.
It describes the contents of this manual and refers to a list of related manuals for
more information. It also contains a flowchart of steps for checking the delivery,
installing and commissioning the drive. The flowchart refers to chapters/sections in
this manual.
Applicability
The manual is applicable to the ACS150 drive firmware version 1.35b or later. See
parameter 3301 FIRMWARE on page 115.
Target audience
The reader is expected to know the fundamentals of electricity, wiring, electrical
components and electrical schematic symbols.
This manual is written for readers worldwide. Both SI and imperial units are shown.
Special US instructions for installations in the United States are given.
Purpose of the manual
This manual provides information needed for planning the installation, installing,
commissioning, using and servicing the drive.
Contents of this manual
The manual consists of the following chapters:
• Safety (page 11) gives safety instructions you must follow when installing,
commissioning, operating and servicing the drive.
• Introduction to the manual (this chapter, page 15) describes applicability, target
audience, purpose and contents of this manual. It also contains a quick
installation and commissioning flowchart.
• Operation principle and hardware description (page 19) describes the operation
principle, layout, type designation label and type designation information. It also
shows a general diagram of power connections and control interfaces.
• Mechanical installation (page 23) tells how to check the installation site, unpack,
check the delivery and install the drive mechanically.
• Planning the electrical installation (page 29) tells how to check the compatibility of
the motor and the drive and select cables, protections and cable routing.
To Next Page
Loading...
