Output mode
In the Output mode, you can:
• monitor actual values of up to three group 01 OPERATING DATA signals, one
signal at a time
• start, stop, change direction, switch between local and remote control and set the
frequency reference.
You can transfer to the Output mode by pressing the key until the display shows
text OUTPUT at the bottom.
The display shows the value of one group 01
OPERATING DATA signal. The unit is shown on the
REM
49
.
1
Hz
right. Page 66 tells how to select up to three signals to
be monitored in the Output mode. The table below
shows how to view them one at a time.
How to browse the monitored signals
OUTPUT FWD
66), you can browse them in the Output mode.
If more than one signals have been selected to be monitored (see page
To browse the signals forward, press key repeatedly. To browse
them backward, press key repeatedly.
To Next Page
Loading...
