ABB ACS860 - Page 297

Parameters 297
96.25 Time in minutes
within 24 h
Number of full minutes passed since midnight. For example,
the value 860 corresponds to 2:20 pm.
See parameter 96.24 Full days since 1st Jan 1980.
0 min
1…1439 Minutes since midnight. 1 = 1
96.26 Time in ms within
one minute
Number of milliseconds passed since last minute.
See parameter 96.24 Full days since 1st Jan 1980.
0 ms
0…59999 Number of milliseconds since last minute. 1 = 1
96.29 Time sync source
status
Time source status word.
This parameter is read-only.
-
0000h…FFFFh Time source status word 1. 1 = 1
96.31 Drive ID number Specifies an ID number for the drive. The ID can be read by
an external controller through DDCS, for example, for
comparison with an ID contained by the controller’s
application.
0
0…32767 ID number. 1 = 1
96.39 Power up event
logging
Enables/disables power-up logging. When enabled, an event
(B5A2 Power up) is logged by the drive upon each power-up.
Enable
Disable Power-up event logging disabled. 0
Enable Power-up event logging enabled. 1
No. Name/Value Description Def/FbEq16
Bit Name Description
0 Time tick
received
1 = 1st priority tick received: Tick has been received from 1st priority
source (or from 96.24…96.26).
1 Aux Time
tick received
1 = 2nd priority tick received: Tick has been received from 2nd priority
source.
2Tick interval
is too long
1 = Yes: Tick interval too long (accuracy compromised).
3 DDCS
controller
1 = Tick received: Tick has been received from an external controller.
5 Reserved
7 FbusA 1 = Tick received: Tick has been received through fieldbus interface A.
9 EFB 1 = Tick received: Tick has been received through the embedded fieldbus
interface.
10 Reserved.
11 Panel link 1 = Tick received: Tick has been received from the control panel, or Drive
composer PC tool connected to the control panel.
12 Ethernet tool
link
1 = Tick received: Tick has been received from Drive composer PC tool
through an FENA module.
13 Parameter
setting
1 = Tick received: Tick has been set by parameters 96.24…96.26.
14 RTC 1 = RTC time in use: Time and date have been read from the real-time
clock.
15 Drive On-
Time
1 = Drive on-time in use: Time and date are displaying drive on-time.