ABB FEX300 - Page 94

Parameterization
94 FEX300, FEX500 OI/FEX300/FEX500-EN
Menu / Parameter Value range Description
Device Info / Sensor
User Span Indication of the correction value for the sensor span
Mains Frequency - Mains frequency for the supply power.
Excitation Freq. -
Frequency used to operate the magnet coils of the
flowmeter sensor.
Coil Current -
Current used to operate the magnet coils of the
flowmeter sensor.
Pre-Amp -
Indication whether a preamplifier exists in the
flowmeter sensor or not (Yes / No).
Sensor ID - ID number of the sensor.
SAP / ERP No. - Order number of the sensor.
Term Board S/W -
Software version of the sensor memory integrated in
the sensor.
Sensor Run Hours - Run hours of the flowmeter sensor.
Calibration
Select the "Calibration" submenu.
Properties
Select the "Properties" submenu.
Device Information / Sensor / Calibration
First Cal. Date -
Date of first calibration of sensor (calibration of new
device).
Last Cal. Date - Date of last calibration of sensor.
Cal. Cert. No. -
Identification (no.) of the relevant calibration
certificate.
First Cal. Location - Place of first calibration of the sensor.
Last Cal. Location - Place of last calibration of sensor.
Cal. Mode - Calibration mode of the sensor.
Cal. Status - Calibration status of the sensor.
Device Info / Sensor / Properties
Electrode Material - Electrode material of the sensor.
Lining Material - Liner material of the sensor.
italics = Parameter can only be viewed at the "Advanced" password level.
1) Parameter / menu only available for FEP500 / FEH500.