ABB FEX300 - Page 95

Parameterization
OI/FEX300/FEX500-EN FEX300, FEX500 95
Menu / Parameter Value range Description
Device Info / Acquisition
Rate ADC - Display for service purposes, only.
Analog Reset
Select the "Analog Reset" submenu.
Driver
Select the "Driver" submenu.
Device Info / Acquisition / Analog Reset
Noise Reset Max - Display for service purposes, only.
Noise Reset On -
Device Info / Acquisition / Driver
Driver DAC - Display for service purposes, only.
Loop Control Mode -
Diff Current Control -
Control Timer -
Device Info / Analog Range
Amplifier - Display for service purposes, only.
Adjust CMReject
Select the "Adjust CMReject" submenu.
Adjust Gain 1 ... 64
Select the "Adjust Gain" submenu.
Device Info / Analog Range / Adjust CMReject
CMR Value - Display for service purposes, only.
Device Info / Analog Range / Adjust Gain 1 ... 64
Adjust Gain 1 - Display for service purposes, only.
Adjust Gain 8
Adjust Gain 16
Adjust Gain 64
italics = Parameter can only be viewed at the "Advanced" password level.
1) Parameter / menu only available for FEP500 / FEH500.