Overview
16
The FPBA-01 PROFIBUS DP Adapter module
The FPBA-01 PROFIBUS DP Adapter module is an optional
device for ABB drives which enables the connection of the drive to
a PROFIBUS network. The drive is considered as a slave on the
PROFIBUS network. Through the FPBA-01 PROFIBUS DP
Adapter module, it is possible to:
• give control commands to the drive
(Start, Stop, Run enable, etc.)
• feed a motor speed or torque reference to the drive
• give a process actual value or a process reference to the PID
controller of the drive
• read status information and actual values from the drive
• change drive parameter values
• reset a drive fault.
The PROFIBUS commands and services supported by the
FPBA-01 PROFIBUS DP Adapter module are discussed in the
chapter Communication. Please refer to the user documentation
of the drive as to which commands are supported by the drive.
The adapter module is mounted into an option slot on the motor
control board of the drive. See the drive documentation for module
placement options.
To Next Page
Loading...
Need help?
General
