Drive configuration
48
Table 3. FPBA-01 configuration parameters – Group C
1 DATA IN 1
This parameter represents data word 1 sent by the drive over the
PROFIBUS network. For the contents, see configuration
parameter group B, parameter 1 (DATA OUT 1) on page 45.
2 to 12 DATA IN 2 to DATA IN 12
See parameter 1 above.
Par.
no.
Parameter name Alternative settings Default
setting
1DATA IN 1
(drive to master)
0 to 9999
Format: xxyy, where
xx = parameter group and
yy = parameter index.
4 (Status word)
or
14 (Status word
32-bit)*
2 DATA IN 2* See DATA IN 1 above. 0 or 5 (ACT1)**
3 DATA IN 3 See DATA IN 1 above. 0
4 DATA IN 4 See DATA IN 1 above. 0
5 DATA IN 5 See DATA IN 1 above. 0
6 DATA IN 6 See DATA IN 1 above. 0
7 DATA IN 7 See DATA IN 1 above. 0
8 DATA IN 8 See DATA IN 1 above. 0
9 DATA IN 9 See DATA IN 1 above. 0
10 DATA IN 10 See DATA IN 1 above. 0
11 DATA IN 11 See DATA IN 1 above. 0
12 DATA IN 12 See DATA IN 1 above. 0
*Default setting if the Transparent 32 profile is used.
**Fixed setting with an ACS350 drive.
***Supported only with an ACSM1/ACS850 drive.
To Next Page
Loading...
