Master configuration
51
Master configuration
Overview
This chapter gives information on configuring the PROFIBUS
master station for communication through the FPBA-01
PROFIBUS Adapter module.
Configuring the system
After the FPBA-01 PROFIBUS DP Adapter module has been
mechanically and electrically installed according to the instructions
in previous chapters, and has been initialised by the drive, the
master station must be prepared for communication with the
module.
Configuration of the master station requires a type definition
(GSD) file.
For DP-V0 communication, the file is available from
www.profibus.com
or your local ABB representative (the filename
is ABB_0959.GSD).
For DP-V1 communication, the file is available from your local
ABB representative (the filename is ABB10959.GSD).
Please refer to the master station documentation for more
information.
To Next Page
Loading...
