ABB i-bus KNX ABA/S 1.2.1 User Manual

116 pages

To Next Page

To Previous Page

ABB i-bus

KNX

Parameters

ABA/S 1.2.1 | 2CDC509086D0201 29

7 Parameters

7.1 General

ETS Engineering Tool Software is used to parametrize the device. The device uses an ETS plug-in.

In ETS, the application is located in the Catalogs window under Manufacturers/ABB/Controller/Controller.

The following sections describe the device functions and parameters.

Questions and Answers:

Need help?

Do you have a question about the ABB i-bus KNX ABA/S 1.2.1 and is the answer not in the manual?

General