ABB i-bus KNX ABA/S 1.2.1 User Manual

ABB i-bus
®
KNX
Parameters
ABA/S 1.2.1 | 2CDC509086D0201 33
7.3 Monitor
The Monitor function provides a real-time view of the current states of the logic in a device. For this to
work, the device must be connected to the network. To start the Monitor, click the following icon:
Fig. 7: Monitor
The plug-in then tries to establish a connection to the logic controller, using the IP address from the ETS
settings (Properties > "IP" tab).
While using Monitor mode, the "Display Mode" option in the application controller web interface settings
must be enabled. This is disabled by default for security reasons.
When a connection has been established, the current states of the I/O logic link objects are displayed.
Note that the Monitor function can only work if the logic in the device and the plug-in is the same.

ABB i-bus KNX ABA/S 1.2.1 Specifications

General

Brand	ABB
Model	i-bus KNX ABA/S 1.2.1
Category	Controller
Language	English