NoteEquipment
Replace if damaged.O-ring for base cover
Installing an expansion container
Use this procedure to install the expansion container.
InfoAction
See Lifting and turning a suspended
mounted robot on page 71.
Lift the robot using the lifting accessory and
place it in suspended position with the base
free for installation work.
1
Remove the cover and the o-ring from the
base.
2
The screws must be replaced with longer
screws.
Remove the two existing attachment screws.3
Remove the oil plug.4
Apply some grease on the small o-ring and
place it in the recess on the expansion con-
tainer.
5
Place the expansion container in the base
and place it so the drain holes match.
6
Secure the expansion container with the at-
tachment screws and washers.
7
Check the o-ring used on the cover. Replace
it if damaged.
8
Refit the cover on the base with its attach-
ment screws.
9
Turn the robot so it is not suspended.10
See procedure for filling, Changing the
oil, axis 1 gearbox on floor mounted ro-
bots on page 153.
Add 0.4 liters of oil to the gearbox.11
Turn the robot to suspended position.12
See procedure for suspended robot, In-
specting oil level, axis-1 gearbox on
page 121.
Inspect the oil level.13
Product manual - IRB 2600 103
3HAC035504-001 Revision: G
© Copyright 2009-2015 ABB. All rights reserved.
2 Installation and commissioning
2.5.2 Installing an expansion container
Continued
To Next Page
Loading...
