3.3.10 Inspecting dampers
Location of dampers
The figure shows the location of all dampers to be inspected.
The figure shows IRB 2600 with Standard upper arm.
xx0800000297
Dampers axis 2 (IRB 2600 Standard and ID)A
Dampers axis 3 (IRB 2600 Standard and ID)B
Damper axis 5 (only on IRB 2600 Standard)C
Required equipment
NoteSpare part no.Equipment
See Spare part lists on
page 387.
Damper
Content is defined in section
Standard tools on page 383.
-Standard toolkit
Continues on next page
Product manual - IRB 2600 145
3HAC035504-001 Revision: G
© Copyright 2009-2015 ABB. All rights reserved.
3 Maintenance
3.3.10 Inspecting dampers
To Next Page
Loading...
