3.5 Cleaning
3.5.1 Cleaning the IRB 2600
WARNING
Turn off all electrical power supplies to the manipulator before entering its work
space.
General
To secure high uptime it is important that the IRB 2600 is cleaned regularly. The
frequency of cleaning depends on the environment in which the manipulator works.
Different cleaning methods are allowed depending on the type of protection of the
IRB 2600.
Note
Always verify the protection type of the robot before cleaning.
Oil spills
Oil spills from gearboxes
Use the following procedure if any oil spills are detected that can be suspected to
originate from a gearbox.
1 Inspect that the oil level in the suspected gearbox is according to the
recommendations, see Inspection activities on page 121.
2 Write down the oil level.
3 Inspect the oil level again after, for example, 6 months.
4 If the oil level is decreased then replace the gearbox.
Oil spills discolors painted surfaces
Oil spills on painted surfaces of the robot can result in discoloration.
Note
After all repair and maintenance work involving oil, always wipe the robot clean
from all surplus oil!
Dos and don'ts!
This section specifies some special considerations when cleaning the robot.
Always!
• Always use cleaning equipment as specified above! Any other cleaning
equipment may shorten the life of the robot.
• Always check that all protective covers are fitted to the robot before cleaning!
Continues on next page
Product manual - IRB 2600 185
3HAC035504-001 Revision: G
© Copyright 2009-2015 ABB. All rights reserved.
3 Maintenance
3.5.1 Cleaning the IRB 2600
To Next Page
Loading...
