DescriptionRevision
This revision includes the following updates:G
• Splitted instruction for fork lift accessory use in two sections.
• Illustrations of SMB battery RMU improved,
This revision includes the following updates:H
• Article number for label updated (Combined warning label "Brake re-
lease", "Brake release buttons" and "Moving robot")
Published in release R16.2. The following updates are made in this revision:J
• Drawing of base plate is not available for purchase, faulty information
removed in Securing the base plate on page 66.
• Corrections due to updates in terminology.
Published in release R17.1. The following updates are made in this revision:K
• Added labels to the robot, one warning label (A) on the axis-6 motor,
one battery label (N) and one stock robots label (P) See Inspecting
the information labels on page 111.
• New standard calibration method is introduced (Axis Calibration). See
Calibration on page 347.
Published in release R17.2. The following updates are made in this revision:L
• Caution about removing metal residues added in sections about SMB
boards.
• Information about minimum resonance frequency added.
• Bending radius for static floor cables added.
• Updated list of applicable standards.
• Article number for the Calibration tool box, Axis Calibration is changed.
• Added text regarding overhaul in section specification of maintenance
intervals.
• Updated the section Start of robot in cold environments on page 93.
• Updated information regarding replacement of brake release board.
• Lifting robot with roundslings updated.
• Updated information regarding disconnecting and reconnecting battery
cable to serial measurement board.
Published in release R18.1. The following updates are made in this revision:M
• Information added about fatigue to Axis Calibration tool, see Calibration
tools for Axis Calibration on page 359.
• Added section, Cut the paint or surface on the robot before replacing
parts.
• New spare part numbers brake release board.
• Note added to calibration chapter to emphasize the requirement of
equally dressed robot when using previously created reference calib-
ration values.
• Information about myABB Business Portal added.
Published in release R18.2. The following updates are done in this revision:N
• Added locating hole position in tool flange view.
Published in release R18.2. The following updates are done in this revision:P
• Updated references.
12 Product manual - IRB 460
3HAC039842-001 Revision: P
© Copyright 2012-2018 ABB. All rights reserved.
Overview of this manual
Continued
To Next Page
Loading...
Need help?
General