E Tilthouse
F Press washer (3HAC040028-002)
G Threaded bar M16
H Hydraulic cylinder
Press tool for removal of shaft
The press tool replacing shaft is used both for removal and refitting. See figure
how to use the tool depending on purpose. For art. no. see Required equipment
on page 192.
The press tool replacing shaft and auxiliary bushing applied as shown in the figure
is used to disassemble the shaft.
The press tool consists of the parts shown in the figure.
xx1100000252
A Thread washer (2 pcs)
B Auxiliary shaft (3HAC040035-001) Only used on removal.
C Shaft axis 2
D Upper arm
E Tilthouse
F Support bushing (3HAC040029-002)
G Hydraulic cylinder
H Threaded bar M16
Press tool for fitting of shaft
The press tool replacing shaft is used both for removal and refitting. See figure
how to use the tool depending on purpose. For art. no. see Required equipment
on page 192.
The press tool replacing shaft applied as shown in the figure is used to fit the shaft.
The press tool consists of the parts shown in the figure. NOTE! The thread washer
Continues on next page
194 Product manual - IRB 460
3HAC039842-001 Revision: P
© Copyright 2012-2018 ABB. All rights reserved.
4 Repair
4.4.2 Replacing the tilthouse unit
Continued
To Next Page
Loading...
Need help?
General