3 Maintenance
3.4.7. Oil change, gearbox axis 6
3HAC020993-001 Revision: G174
© Copyright 2004-2008 ABB. All rights reserved.
3. Remove the oil plug, filling. Shown in the figure Location of
gearbox on page 172!
4. Refill the gearbox with lubricating oil.
The amount of oil to be refilled depends on the
amount previously being drained. The correct oil
level is detailed in section Inspection, oil level
gearbox axis 6 on page 127.
Art. no. and the total amount
are specified in Required
equipment on page 172!
5.
WARNING!
Do not mix the oil types! If wrong oil is refilled, the
gearbox must be rinsed as detailed in section
WARNING - Mixed oils may cause severe damage
to gearbox! on page 40!
6. Note! Don´t mix Kyodo Yushi TMO 150 with other oil
types!
Detailed in section Oil in
gearboxes on page 151.
7. Refit the oil plug. Tightening torque: 24 Nm.
Action Note
Continued
To Next Page
Loading...
