4 Repair
4.3.6. Replacement of air nipple and hose (Foundry Prime)
2373HAC020993-001 Revision: G
© Copyright 2004-2008 ABB. All rights reserved.
Required equipment
Procedure
The following procedures details how to replace the Foundry Prime air nipples and hose. The
pos. no. in following procedures correspond to the illustration in Hose lengths on page
236and the table in Required equipment on page 237
1E 200
1F 35
1G 250
1H 730
1K 4290
1L 195
1M 40
1N 40
1P 1605
1Q 100
1R 1490
1S 570
Pos Length in mm.
Equipment Art. no. Pos. in illustration
Velcro strap 3HAC12625-1 9
Cable straps 21662055-3 8
Elbow fitting 40 6
Rubber clamp 3HAC026523-001 5
T-plug connector 3HAC026515-001 4
Y-plug connector 3HAC026514-001 3
Bulkhead plug connector 3HAC026513-001 2
Hose 3HAC026526-001 1
Action Note/Illustration
<<
DANGER!
Turn off all electric power, hydraulic and
pneumatic pressure supplies to the robot.
Localise the damaged hose or air
connector, and Continue to replace the
damaged hose route the hose according to
the following illustrations
Continued
Continues on next page
To Next Page
Loading...
