Replacing the synchronization mark plate
The design of the turning disc spare part might require replacement of the axis-6
synchronization mark plate if the existing plate is not compatible with the new
turning disc.
If ordering a new turning disc, the synchronization mark plate required is enclosed
with the spare part. Check if the robot is already equipped with a compatible plate
or if it needs to be replaced. The difference is shown in the figures.
Compatible axis-6 synchronization mark
plate on robot
Incompatible axis-6 synchronization mark
plate on robot
xx1500000874xx1500000873
Compatible synchronization mark plate is in-
stalled.
Incompatible synchronization mark plate is
installed.
No action required.Replace the plate.
Fitting the axis-6 synchronization mark plate
There are different attachment holes on the plate used for different robot variants.
See table below.
IRB 6700 - 300/2.70, IRB 6700 - 245/3.00IRB 6700 - 235/2.65, IRB 6700 - 205/2.80, IRB
6700 - 175/3.05, IRB 6700 - 150/3.20, IRB
6700 - 200/2.60, IRB 6700 - 155/2.85
xx1500000878xx1500000877
Use the holes at the back end of the synchron-
ization plate.
Use the holes closest to the synchronization
mark.
Continues on next page
368 Product manual - IRB 6700
3HAC044266-001 Revision: N
© Copyright 2013 - 2018 ABB. All rights reserved.
4 Repair
4.5.3 Replacing the turning disc
Continued
To Next Page
Loading...
