Refitting the process turning disc
Use this procedure to refit the process turning disc.
Screw joint for refitting process turning disc
Tightening
torque
Number of
washers
Number of
screws
Screw dimen-
sion
Variant
35 Nm24 pcs24 pcsM8x25IRB 6700 - 235/2.65
35 Nm24 pcs24 pcsM8x25IRB 6700 - 205/2.80
35 Nm24 pcs24 pcsM8x25IRB 6700 - 175/3.05
35 Nm24 pcs24 pcsM8x25IRB 6700 - 150/3.20
70 Nm3 pcs9 pcsM10x25IRB 6700 - 200/2.60
70 Nm3 pcs9 pcsM10x25IRB 6700 - 155/2.85
70 Nm21 pcs21 pcsM10x25IRB 6700 - 300/2.70
70 Nm21 pcs21 pcsM10x25IRB 6700 - 245/3.00
Refitting the process turning disc
NoteAction
See Replacing the synchronization mark
plate on page 373.
If new turning disc spare part is installed:
verify that the correct synchronization mark
plate for axis-6 is installed on the wrist.
1
Wipe clean the contacts surfaces.2
Foundry Plus:
Apply Mercasol on the surfaces on the
process turning disc and axis-6 gearbox
as shown in the figure.
3
The figure show standard turning disc.
Surfaces to apply Mercasol on are the
same with process turning disc.
Tightening torque: 35 Nm.IRB 6700 -235/2.65, -205/2.80, -175/3.05, -
150/3.20.
4
Attachment screws: M8x25, Steel 12.9
Gleitmo 603 (24 pcs)Secure the process turning disc with its
attachment screws and washers.
Washers: Steel 8.4x13x1.5 (24 pcs)
Continues on next page
Product manual - IRB 6700 375
3HAC044266-001 Revision: N
© Copyright 2013 - 2018 ABB. All rights reserved.
4 Repair
4.5.4 Replacing the process turning disc
Continued
To Next Page
Loading...
