Removing the spherical roller bearing, link ear
NoteAction
Check that the link ear is in a position
where it is possible to apply the dismantle
and mounting tool. If not, adjust with the
lifting accessory.
1
xx1300000774
Unscrew the attachment screws securing
the end cover, remove end cover and radial
sealing with a screwdriver.
2
xx1300000775
Remove the o-ring.3
Dismantle and mounting tool:
3HAC028920-001
xx1300000840
A Spherical roller bearing
B Radial sealing
C Washer
Apply the dismantle and mounting tool and
pull the spherical roller bearing out together
with the radial sealing and washer.
4
Continues on next page
452 Product manual - IRB 6700
3HAC044266-001 Revision: N
© Copyright 2013 - 2018 ABB. All rights reserved.
4 Repair
4.6.1 Replacing spherical roller bearing, link ear
Continued
To Next Page
Loading...
