NoteAction
Screws: M10 quality 12.9.Apply flange sealant and refit the cover
plate on the back of the balancing device.
7
Tightening torque: 50 Nm.
Flange sealant for conical fittings: Loctite
577.
xx1300000554
DANGER
Make sure all safety requirements are met
when performing the first test run. These
are further detailed in the section First test
run may cause injury or damage on
page 26.
8
Product manual - IRB 6700 491
3HAC044266-001 Revision: N
© Copyright 2013 - 2018 ABB. All rights reserved.
4 Repair
4.6.3 Replacing the rear bearings on the balancing device
Continued
To Next Page
Loading...
