ABB IRB 6700 Series - Page 512

NoteAction
Connect the 24 VDC power supply to re-
lease the brakes.
5
To release the brakes, connect the 24 VDC
power supply as described in the list.
Connect to R2.MP1-connector:
• + = pin 2
• - = pin 5
CAUTION
Whenever parting/mating motor and gear-
box, the gears may be damaged if excess-
ive force is used.
6
Lifting accessory (chain): 3HAC15556-1Lower the motor into position.
• Make sure that the motor pinion is
properly mated to the gear in the
gearbox.
• Make sure that the motor pinion
does not get damaged.
• Make sure that the direction of the
cable gland exit is facing the correct
way.
7
Lifting accessory, motor: 3HAC14459-1.
xx1200001072
Bits extender: 3HAC12342-1Secure the motor with its attachment
screws and washers.
8
Tightening torque: 50 Nm.
Use a bits extender to reach the screws.
Screws: M10x30 Steel 12.9 Gle
603+Geo500 (4 pcs)
xx1200001071
Continues on next page
512 Product manual - IRB 6700
3HAC044266-001 Revision: N
© Copyright 2013 - 2018 ABB. All rights reserved.
4 Repair
4.7.1 Replacing the axis-1 motor
Continued