Refitting the axis-1 gearbox
These procedures describe how to refit the axis-1 gearbox.
Preparations before refitting the axis-1 gearbox
NoteAction
xx1000000364
If not already done, fit and secure the four
support legs to the foundation. Then lift up
and secure the base on top of the legs.
1
A Support legs: 3HAC15535-1.
Lifting eye: 3HAC14457-4
xx1700000325
Fit two lifting eyes in opposite holes in the
gearbox.
CAUTION
Leave a couple of millimeters of space
between the lug and the surface of the gear-
box. This is done in order not to damage the
surface of the gearbox which is a sealing
surface.
2
CAUTION
The weight of the gearbox is
92 kg (IRB 6700 -235/2.65, -205/2.80,
-175/3.05, -150/3.20, -200/2.60, -155/2.85)
140 kg (IRB 6700 -300/2.70, -245/3.00)
All lifting accessories used must be sized
accordingly.
3
Continues on next page
Product manual - IRB 6700 645
3HAC044266-001 Revision: N
© Copyright 2013 - 2018 ABB. All rights reserved.
4 Repair
4.8.2 Replacing the axis-1 gearbox (IRB 6700 - 300/2.70, IRB 6700 - 245/3.00)
Continued
To Next Page
Loading...
