Refitting the gearbox
Use this procedure to refit the gearbox.
NoteAction
CAUTION
The gearbox weighs according to vari-
ant110 kg.
All lifting accessories used must be sized
accordingly!
1
Lifting accessory, gearbox:Apply the lifting accessory to the gearbox.2
3HAC046112-001
i
3HAC046128-001
ii
Use caution and lift the gearbox so that it
rests on its side.
3
Remove the o-ring and wipe it clean.
Note
This must also be done on a new spare
part!
4
Wipe clean the contact surfaces from any
contamination.
Note
Also wipe clean the o-ring groove.
5
Check the condition of the o-ring.6
Replace if damaged.
Lubricate the o-ring with some grease, for
a better fitting in the groove.
7
Fit the o-ring in the groove.8
xx1400000374
Foundry Plus:
Apply Mercasol on the surfaces shown in
the figure.
9
Continues on next page
Product manual - IRB 6700 721
3HAC044266-001 Revision: N
© Copyright 2013 - 2018 ABB. All rights reserved.
4 Repair
4.8.4 Replacing the axis-2 gearbox (IRB 6700 - 300/2.70, IRB 6700 - 245/3.00)
Continued
To Next Page
Loading...
