NoteAction
Tightening torque, transparent
plug: 25 Nm ±10%.
Foundry Plus:
Valid for axis-2, axis-3, axis-4 and axis-6 motors.
6
Tightening torque, protection filter:
10 Nm ±10%.
xx1600000576
If the motor is a new spare part, the evacuation
hole protection filter must be replaced with a
transparent plug/sight glass (enclosed with the
spare part delivery). Remove the protection filter
and install the transparent plug/sight glass.
On the axis-6 motor there are two protection filters
that must be replaced with transparent plugs/sight
glasses.
xx1800000102
Transparent plug
(Foundry Plus).
xx1800000101
Protection filter (Stand-
ard).
Securing the axis-3 motor
Use this procedure to secure the motor.
NoteAction
Guide pin, M10x150: 3HAC15521-2Fit guide pins in opposite holes.1
Always use guide pins in pairs.
CAUTION
The motor weighs 26 kg.
All lifting accessories used must be sized
accordingly.
2
Lifting accessory, motor: 3HAC15534-1
xx1700000273
Apply the lifting accessories to the motor.
Note
Make sure the cable gland exit is turned ac-
cording to figure.
3
Continues on next page
768 Product manual - IRB 6700
3HAC044266-001 Revision: N
© Copyright 2013 - 2018 ABB. All rights reserved.
4 Repair
4.8.5 Replacing the axis-3 gearbox
Continued
To Next Page
Loading...
