Inspecting the oil level in axis-5 gearbox
Use this procedure to inspect the oil level in the gearbox.
NoteAction
xx2200001458
Run the robot to calibration position.1
DANGER
Turn off all:
• electric power supply
• hydraulic pressure supply
• air pressure supply
to the robot, before entering the safe-
guarded space.
2
Make sure that the oil temperature is +25°C
± 10°C.
3
WARNING
Handling gearbox oil involves several
safety risks, see Gearbox lubricants (oil or
grease) on page 29.
4
xx2200002137
Open the oil plug.5
Check the oil level.6
Required oil level is: 0-10 mm below oil
plug hole.
Continues on next page
Product manual - IRB 6710 131
3HAC085695-001 Revision: A
© Copyright 2023 ABB. All rights reserved.
4 Maintenance
4.3.11 Inspecting the oil level in axis-5 gearbox
Continued
To Next Page
Loading...
