NoteAction
xx2000000378
Remove the motor by lifting it straight up
from the gear.
Make sure the motor pinion is not dam-
aged!
8
Disconnect the brake release tool.9
Refitting the motor
Use these procedures to refit the motor.
Preparations prior to refitting motor
NoteAction
DANGER
Make sure that all supplies for electrical power,
hydraulic pressure, and air pressure are turned
off.
1
Cleaning agent: Loctite 7200, Loc-
tite 7063
Remove any old paint or flange sealant residues
or other contamination from the contact surfaces
on both the motor and the mating parts.
Tip
Remove flange sealant residues with Loctite 7200.
Then use Loctite 7063 for cleaning the mating
surface.
2
Continues on next page
Product manual - IRB 6710 423
3HAC085695-001 Revision: A
© Copyright 2023 ABB. All rights reserved.
5 Repair
5.7.6 Replacing the axis-6 motor
Continued
To Next Page
Loading...
