NoteAction
DANGER
Turn off all:
• electric power supply
• hydraulic pressure supply
• air pressure supply
to the robot, before entering the robot working
area.
2
Shown in figure Location of oil plugs
on page 133.
Drain oil from gearbox into a vessel by removing
oil plug, draining.
Also remove oil plug, filling.
3
Vessel capacity is specified in Re-
quired equipment on page 133.
Tightening torque: 24 Nm.Refit oil plugs, draining and filling.4
Filling, oil
Use this procedure to fill gearbox axis 6 with oil.
When using oil change equipment, follow the instructions enclosed with kit.
NoteAction
DANGER
Turn off all:
• electric power supply
• hydraulic pressure supply
• air pressure supply
to the robot, before entering the robot working
area.
1
Shown in figure Location of oil
plugs on page 133.
Remove the oil plug, filling.2
Art. no. and the total amount are
specified in Required equipment
on page 133.
Refill the gearbox with lubricating oil.
Amount of oil to be refilled depends on the
amount that was previously drained. Correct oil
level is detailed in section Inspection, oil level
axis-6 gearbox on page 107.
3
Tightening torque: 24 Nm.Refit the oil plug.4
134 Product manual - IRB 760
3HAC039838-001 Revision: M
© Copyright 2011-2018 ABB. All rights reserved.
3 Maintenance
3.4.4 Changing oil, gearbox axis 6
Continued
To Next Page
Loading...
