ABB IRB 760 Series - Replacing the cable harness, upper end (incl. axis 6)

4.3.2 Replacing the cable harness, upper end (incl. axis 6)
Overview
Replacement of the cable harness is detailed in two steps - lower end (axes 1-3)
and upper end. The procedure below details replacement of the cable harness in
the upper end (incl. axis 6). The procedure for replacing the lower end (axis 1-3)
is detailed in section Replacing cable harness, lower end (axes 1-3) on page 153.
Location of cable harness, upper end
The upper end of the cable harness is located as shown in the figure.
xx1000001176
Continues on next page
Product manual - IRB 760 163
3HAC039838-001 Revision: M
© Copyright 2011-2018 ABB. All rights reserved.
4 Repair
4.3.2 Replacing the cable harness, upper end (incl. axis 6)