NoteAction
Press the push buttons 1 to 6, one at a time,
to make sure that the buttons are moving
freely and do not stay in a locked position.
9
Detailed in the Calibration chapter -
section Updating revolution counters
on page 356.
If the battery has been disconnected the revolu-
tion counter must be updated.
10
DANGER
Make sure all safety requirements are met
when performing the first test run. These are
further detailed in the section First test run
may cause injury or damage on page 26.
11
Product manual - IRB 760 177
3HAC039838-001 Revision: M
© Copyright 2011-2018 ABB. All rights reserved.
4 Repair
4.3.4 Replacing the brake release board
Continued
To Next Page
Loading...
