NoteArt. no.Equipment, etc.
These procedures include refer-
ences to the tools required.
Other tools and procedures may
be required. See references to
these procedures in the step-
by-step instructions below.
Removing, turning disk
Use this procedure to remove the turning disk.
NoteAction
Run the robot to a position where the tilthouse is
best positioned for the turning disk to be replaced.
1
See Synchronization marks and
synchronization position for axes
on page 353.
Note
This is done in order to fascilitate
fitting of the turning disk in the
correct position.
Rotate axis 6 to its calibration position.2
DANGER
Turn off all:
• electric power supply
• hydraulic pressure supply
• air pressure supply
to the robot, before entering the robot working area.
3
Remove any equipment fitted to the turning disk.4
See section
• Changing oil, gearbox axis
6 on page 133
Drain the axis 6 gearbox.5
xx1000001134
Remove the attachment screws that secure the
turning disk.
6
Continues on next page
Product manual - IRB 760 187
3HAC039838-001 Revision: M
© Copyright 2011-2018 ABB. All rights reserved.
4 Repair
4.4.1 Replacing the turning disk
Continued
To Next Page
Loading...
