NoteArt. no.Equipment etc.
Content is defined in section
Standard tools on page 389.
-Standard toolkit
These procedures include
references to the tools re-
quired.
Other tools and procedures
may be required. See refer-
ences to these procedures in
the step-by-step instructions
below.
Removing the balancing weight
Use this procedure to remove the balancing weight.
NoteAction
Shown in Synchronization marks and
synchronization position for axes on
page 353.
Move the robot to its calibration position.1
DANGER
Turn off all:
• electric power supply
• hydraulic pressure supply
• air pressure supply
to the robot, before entering the robot
working area.
2
xx1000001298
Fit two lifting lugs in the balancing weight.3
CAUTION
The balancing weight weighs 350 kg.
All lifting accessories used must be sized
accordingly!
4
Secure the balancing weight with round-
slings (using the lifting lugs) in an overhead
crane or similar.
5
Continues on next page
288 Product manual - IRB 760
3HAC039838-001 Revision: M
© Copyright 2011-2018 ABB. All rights reserved.
4 Repair
4.5.2 Replacing the balancing weight
Continued
To Next Page
Loading...
