NoteAction
Secure the balancing weight with round-
slings (using the lifting lugs) in an overhead
crane or similar.
3
xx1000001300
Lift the balancing weight and put it in its
position on the parallel arm.
4
For art. no. see:
• Required equipment
Attachment screws: M16x120 (2 pcs)
Put locking liquid (Loctite 243) on the attach-
ment screws.
5
Tightening torque:
• 165 Nm.
xx1000001296
Secure the balancing weight with its attach-
ment screws and washers.
6
DANGER
Make sure all safety requirements are met
when performing the first test run. These
are further detailed in the section First test
run may cause injury or damage on page 26.
7
290 Product manual - IRB 760
3HAC039838-001 Revision: M
© Copyright 2011-2018 ABB. All rights reserved.
4 Repair
4.5.2 Replacing the balancing weight
Continued
To Next Page
Loading...
