Spare parts
When calibration is not being performed, a protective cover and an o-ring should
always be installed on the fixed calibration pin as well as a protective plug, included
a sealing, in the bushing. Replace damaged parts with new, if needed.
NoteArticle numberSpare part
Contains replacement calibration
pin covers and protective plugs
for the bushing.
3HAC056806-001Protection cover and plug set
Product manual - IRB 760 365
3HAC039838-001 Revision: M
© Copyright 2011-2018 ABB. All rights reserved.
5 Calibration
5.4.3 Installation locations for the calibration tools
Continued
To Next Page
Loading...
