Parts shipments must be prepaid by the customer. Any part, not covered by
original system warranty, will be shipped to the customer, F.O.B.
When removing the front or rear end caps, hands can
become coated with a black thread lubricant. If this happens,
wash hands before performing maintenance functions, using
Go-Jo or an equivalent type hand cleanser. The lubricant
must not come in contact with components. Do not wipe
lubricant on clothing as it cannot be removed easily.
If enclosure needs more thread lubricant, use Vaseline.
5.2 Spare Part Components
The information in this section presents the components (see Figure 5-1) and
parts that are accessible for removal and installation. Replacement components
will be covered first in this chapter, followed by instructions for replacing spare
parts.
5.2.1 Replacement Components
The following is a list of components that may be replaced:
• Analytical module (12 or 24 VDC) with or without GC module (see Figure 5-2
)
• GC module
• Digital controller assembly with display
• Termination panel
• Feed-through assembly without preheat (see Figure 5-3
)
• Feed-through assembly with preheat (12 or 24 VDC)
5.2.2 Replacement Parts
The following is a list of parts that may be replaced:
• Lithium Battery
• Frit Filters
• Analytical processor to termination panel cable
• Termination panel to digital controller cable
• Feed-through O-ring
• Feed-through interface gasket
• Feed-through manifold gasket
• Feed-through heater (12 or 24 VDC)
• GC module temperature sensor
To Next Page
Loading...
