6) Insert gas probe into pipeline coupling (see Figure 3-4).
7) Using the correct tool, tighten probe. Securely tighten so there is no gas leakage.
Do not over-tighten.
8) Install shut-off valve on secondary side of sample probe, if desired.
Figure 3-3 Sample Probe
Figure 3-4 Sample Probe Insertion
3.4 Stand Alone Installation
If installing a NGC8201 using a free-standing pipe, use this procedure to install the
pipe. Before beginning, review the procedure and the materials required for
installation.
THREADED NECK 3/4" NPT.
PRESSURE RELIEF VALVE
PRESSURE GUAGE
1/4" OUTLET PORT
3/4" NPT
GAS FLOW
SAMPLE PROBE
CUSTOMER INSTALLED COUPLING
PRESSURE GAUGE
OUTLET PORT 1/4" NPT
RELIEF VALVE
To Next Page
Loading...
