ABB NGC8206 - Figure 3-36 Dual Bottle Rack Assembly

Page 3–36
2101510 Rev. AG
Enclosure hole contains a captive nut.
Figure 3-36 Dual Bottle Rack Assembly
3) Screw the bolt into the captive nut on the large enclosure or nut provided with
small enclosure kit, tighten.
4) Repeat for second bolt.
5) Install carrier gas bottle in bottle rack.
6) Using chains, strap the bottle(s) to the rack by attaching a bolt snap to one of the
center chains.
7) Repeat step 5 if installing a second bottle.