ABB PCS100 UPS-I - 11 Event Codes and Descriptions; Event Code Interpretation and Abbreviations

98 PCS100 UPS-I User Manual
—
11 EVENT CODES AND DESCRIPTIONS
Events, warning and faults for the PCS100 UPS-I are indicated via the GDM and recorded in the event log. A
Summary of all the events, warning and faults are shown in Table 11-2: PCS100 UPS-I Event Descriptions. If the
recommended action does not remedy the warning or fault then contact ABB for assistance. When contacting
ABB a copy of the downloaded event log or service log will typically be required.
NOTICE – Trained Operators
All operations on the PCS100 UPS-I must only be carried out by a trained Operator familiar with the
contents of this manual. Hazardous conditions could arise from incorrect adjustment.
Abbreviation
Description
F
Fault.
A fault has occurred and the PCS100 UPS-I is in Bypass.
The PCS100 UPS-I cannot be started until the fault is removed.
W
Warning.
The PCS100 UPS-I is functioning normally but a warning condition exists.
S
The fault originated from the Auxiliary Master Module, Utility Disconnect, Float Charger or
Fail-Safe Bypass.
I
The fault originated in a PCS100 Inverter module
Table 11-1: Key for abbreviations in Table 11-2