EasyManua.ls Logo

ABB Pulsar Edge - Page 144

ABB Pulsar Edge
202 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 144
© Copyright 2021 ABB. All rights reserved.
net2 is currently only used by an attached Gateway Card in the NX400 system.
NET-Network Settings
Related Commands
Obj,attr Description Sta Cha Ope Type
net1,des Description √ √
net1,ead √
net1,sor √ number
net1,dhcp DHCP √ √ √ number
√ √
IP
address
net1,sub √ √
IP
address
√ √
IP
address
net1,host Hostname √ √
net1,wip √
address)
net1,dom √ √
net1,dns √ √
IP
address
net1,wre √ √
net1,tmo √ √ Minutes
net1,msrv √ √
IP
address
“mailhost”)
net1,ntp √ √
IP
address
ANET- Auxiliary Network Settings
Related Commands
Obj,attr Description Sta Cha Ope Type
net2,des Description
√ √
net2,ena Enable √ √ number
√ √
IP
address
net2,sub √ √
IP
address
√ √
IP
address
net2,host Hostname √ √
net2,dom √ √
net2,msrv
√ √
IP
address
“mailhost”)

Table of Contents