Page 163
© Copyright 2021 ABB. All rights reserved.
Appendix D: Default Configurations
Table 6 through Table 9 provide the default settings for the configurable parameters and features that
are associated in the Pulsar Edge. Also listed are the battery technologies and specific battery models
included in the configuration file previously shown in Appendix C. Specific battery models assume the
configuration defaults for their generic technology class except for a specific capacity and model
name. The generic Valve Regulated Lead Acid battery type will be the factory default Battery Type
selected and configured for the Pulsar Edge configuration. Changes to individual features, parameters,
and thresholds for each battery type will be allowed in the field. These changes will be stored in
non-volatile memory. However, if the Load Factory Defaults control/operation command is initiated, all
assigned values shown in Table 5 and Table 6 through Table 9 will be restored. The configurations
made in the field will be lost unless they were backed-up.
There are five sections for determining the defaults for the standard configuration program file. These
sections are Standard, 48V Battery, 24V Battery, Converters, and Alarms. This document will show
four separate tables for these categories. In addition, the Excel spreadsheet is also attached.
The Standard section includes settings and thresholds independent of the primary output voltage of
the system. Generally, these items are set using information that does not depend on the battery
reserve system.
The 48V Battery section includes settings and thresholds that are generally dependent of the primary
48V output voltage of the system. Generally, these items are set using information that depends on the
battery reserve system configured.
The 24V Battery section includes settings and thresholds that are generally dependent of the primary
24V output voltage of the system. Generally, these items are set using information that depends on the
battery reserve system configured.
The Converters section contains the settings and thresholds associated with DC/DC converters and
converter systems.
The Alarms section provides the assigned severities, alarm output relays (if present), and LED
assignments for the standard configuration.
This document will continue to be revised and updated as feedback and additional requirements come
in from the field or as new configurable features and thresholds are added to the standard Pulsar Edge.
Features, thresholds, and other configurable items not addressed in the list will remain at the factory
default set for each respective item as defined in the standard product offering. Note: Custom
configurations can be made available through configuration of application or customer preferred
defaults for the information in the following tables for certain application.
To Next Page
Loading...
Need help?
General
