Page 196
© Copyright 2021 ABB. All rights reserved.
followed:
1. Contact ABB Critical Power at the 24/7 technical support contacts at either techsupoort@abb.com or 1-877-546-
3243 or 1-972-244-9288 (DC Systems Option 2) for the certificate file.
2. Change the file extension to ".crt"
3. Right click on the certificate file ASDC_2048.crt and select: "Install Certificate"
4. When prompted select: "Place all certificates in the following store"
5. Browse to select: "Trusted root certification authorities"
The device certificate created by the controller identifies the controller by its IPv6 address. Whenever
the IP address of a controller is changed, it is necessary to reboot the controller. Allow about a minute
and a half for all the changes to be stored prior to rebooting. Upon reboot, the controller will create a
device certificate for the new IP address. This process may take several minutes. Now the “https:”
prepended URL can be used to access error free connection. Note: an IPv6 address must be enclosed in
[ ] when in a URL. Sample web screen follows.
Figure 30: Mismatched Address Certificate Error Screen
Figure 31: HTTPS Connectivity Over IPv6 Controller Login Screen
To Next Page
Loading...
Need help?
General
