Page 65
© Copyright 2021 ABB. All rights reserved.
In addition to the maintenance page T1.317 button, a user can click on the Command Line Interface, CLI,
button shown below which is located on every page for quick access.
Reboot
The maintenance page provides a Reboot button that issues a T1.317 command line reboot command
over the network. The controller will reboot upon receiving this command and connectivity will have to
be reestablished.
Settings Tab - Configuration
The Settings page is where system operational parameters, system device information, and alarm
thresholds are set-up and modified. Configurable parameters are sectioned under five main headings:
System, Reserve, Power, Communication, and Programming. Factory defaults are provided for the
various configurable items in the standard Pulsar Edge controller. Some defaults are dependent on the
battery type. Consult Appendix E for default settings of different battery. Valve-Regulated Lead Acid
(VRLA) batteries and default settings defined for the Standard configuration are assumed in this
section. Customer specific configurations may be different. When there is doubt, contact ABB technical
support.
All items are field configurable. Modified settings are stored in non-volatile memory. The Pulsar Edge
requires time to update sectors in flash memory for changes. Allow approximately a minute for the
Pulsar Edge to accept and store modifications in non-volatile memory before removing power to the
unit.
CLI but-
To Next Page
Loading...
Need help?
General
