Page 37
© Copyright 2021 ABB. All rights reserved.
Status LEDs
The Pulsar Edge controller family provides two separate LED indicators that can be used to provide a
high level first glance local indication at the site of the status of the power system and its monitored
inputs. These LEDs can be configured to assist in providing more specific indications of the system
status. The LEDs provided are used to provide specific indication concerning the system status as well
as a separate indicator for an assigned alarm or alarms. The alarm LED has factory assigned defaults
as indicated in the table below. However, the assignments to alarms can be customized in the field
using the remote interfaces.
Status Function Condition
Normal
Normal operation, no alarms, inputs and ou
Medium severity. Generally assigned to alarm to indicate a
non-power affecting
LED LED Color Status Condition
Severity
Normal
Normal operation, no alarms, inputs and ou
Alarm
BD
Not System above configured Battery on
This state is not assigned by the present
To Next Page
Loading...
Need help?
General
