Page 39
© Copyright 2021 ABB. All rights reserved.
A user must enter the PIN for items that generally are not deemed as functions of a typical
maintenance routine. It is assumed that the majority of the configured thresholds and system
operational features will not be changed through a maintenance routine. Thus, entering the correct PIN
will be required in order for these specific types of parameters or features to be modified in the field.
These same rules are implemented when accessing through the Craft port. In addition to Configuration
items, there are some Control/Operations that also require the PIN. These are shown below.
Control/Operations that require PIN
1. Clear History
2. Clear Statistics
3. Disconnects – Manual disconnect/reconnect of any LVLD/LVBD
4. Enter Boost
Control/Operations that do not require PIN
1. Lamp Test
2. Restart Rectifiers
3. Uninstall Equipment
4. Start Battery Test
5. Start Alarm Test
6. Load Factory Defaults
7. Cut-off Audible Alarm
All configuration items from the front panel require PIN access except for a few.
Configuration not requiring PIN
1. Battery Type
2. String Battery Capacity (AH)
3. Number Of Battery Strings
4. Manual Discharge Test Type
5. Manual Test Duration
6. Manual Test Check Battery Alarm Voltage Threshold
7. Battery Test Rectifier Voltage
8. System Date Format
9. System Date
10. System Time Format
11. System Time
12. Automatic Daylight Savings Feature
13. Display Contrast
14. Temperature Display Units
15. Alarm Test Feature
16. Alarm Test Relay Duration and Relay
To Next Page
Loading...
Need help?
General
