REG 316*4 1MRB520049-Uen / Rev. E ABB Switzerland Ltd
5-7
Installation on a hard disc under Windows 95 / NT 4.0:
1. Insert the first disc “Disk 1/4” into drive A.
2. Click on ‘Start’ on the task bar at the bottom of the screen.
Select ‘Run’ in the menu that then opens and enter ‘a:\setup’.
Simply follow the instructions on the screen for the remainder of
the procedure. The installation of the remote HMI shell is op-
tional. Respond appropriately to the requests for language, drive,
directory and program group.
HMI files and configuration
After installation, the following files amongst others are in the
HMI directory:
· pcgc91.exe: operator program.
· re*.cfg: configuration file.
· readme.e: text file with explanations of the in-
stallation procedure and the latest
information about new SW ver-
sions.
· diststd.bin: distance protection function logic.
· aurestd.bin: auto-reclosure function logic.
· Sub-directory VDEW6: VDEW6 function logic.
Before the operator program can be executed, the device driver
“ansi.sys” has to be loaded. The installation program automati-
cally modifies the configuration files for the operating system.
DOS, Windows 3.x:
In the file C:\CONFIG.SYS:
device=c:\dos\ansi.sys.
Windows 95:
In the file C:\CONFIG.W40:
device=c:\win95\command\ansi.sys
Windows NT 4.0:
In the file C:\WINNT\SYSTEM32\CONFIG.NT:
device=%SystemRoot%\system32\ansi.sys
To Next Page
Loading...
