PTS PRESSURE TRANSMITTER
CREATE/MODIFY CONFIGURATION
E - 2
Key Display Comments
Select NEW to create a configuration. To modify an
existing configuration, select MODIFY. The screen
sequence is the same, however, the MODIFY
screens will appear with the values and arrow posi-
tions as they were originally configured.
Select ABB FSK.
Use the down arrow key to select PTS.
Enter a name for the configuration ID tag using up to
14 ASCII characters. To select a character, press the
key that has the desired character. Continue to press
the key until the desired character appears. Use the
right arrow key to move to the next character. Use
the left arrow key to go back to the previous charac-
ter.
Select ANALOG.
NOTE: The DIGITAL selection should only be made
when using an IMFBS01 field bus I/O module. A
CHANNEL # prompt appears when DIGITAL is
selected.
Select LINEAR. For a function generator example,
refer to Appendix G.
Use
to return to a previous configuration
screen from any screen in the configuration process.
Use the arrow keys to select an output action.
Enter a value between 0 and 32 seconds.
CONFIG
CONFIGURATION
→ NEW
MODIFY
ERASE
ENTER
DEVICE TYPE
→ ABB FSK
HART
ENTER
TRANSMITTER TYPE
→ PTS EQS
BCN EQN
AVS TB480 cond
ENTER
STT04 CONFIGURATION
[]
←PREVIOUS NEXT→
ENTER
SELECT MODE:
→ ANALOG
DIGITAL
ENTER
OUTPUT TYPE:
→ LINEAR
SQUARE ROOT
3/2 FLOW MODE
BACK
ENTER
OUTPUT ACTION:
→ NORMAL
REVERSE
ENTER
DAMPING:
(0 - 32 SEC)
_ nn.nn SEC
To Next Page
Loading...
