INTRODUCTION
K - 1
APPENDIX K - TBN580 TRANSMITTER
INTRODUCTION
This appendix covers the configuration and calibration functions of
the TBN580 Transmitter. Refer to OPERATING PROCEDURES in
Section 4 for information on the following functions:
NOTE: To change calibration or configuration parameters of a smart
field device that is connected to an IMFBS01 module, the device
must be taken off-line. This is done at the INFI 90 OPEN console.
CREATE/MODIFY CONFIGURATION
A configuration can be created off-line, without a connected field
device. Refer to Figure K-1 for an overview of the configuration func-
tion of the TBN580 pH transmitter. The following table details the con-
figuration process.
• Send configurations. • Select configurations.
• Get configurations. • Erase configurations.
• View configurations. • Operational functions.
Figure K-1. Configuration Flowchart (TBN580)
T01337A
SELECT
TEMPERATURE
COMPENSATION
TYPE
SELECT MODE
ENTER
CHANNEL
NUMBER
SELECT FAIL
MODE
DIGITAL
ANALOG
SELECT
TRANSMITTER
TYPE
SELECT
OUTPUT
ACTION
SELECT
TEMPERATURE
DISPLAY UNITS
SPECIFY
FUNCTION
GENERATOR
SELECT
INITIALIZE
MODE
SELECT pH
SENSOR INPUT
ENTER
DAMPING
CONSTANT
SAVE
CONFIGURATION
ENTER LOWER
RANGE VALUE
ENTER
SECONDARY
LOWER/UPPER
RANGE VALUES
ENTER
SECONDARY
UNITS
ENTER
SOLUTION
COEFFICIENT
C
O
N
F
I
G
U
R
E
SELECT
TEMPERATURE
COMPENSATION
INPUT
ENTER UPPER
RANGE VALUE
To Next Page
Loading...
