INTRODUCTION
M - 1
APPENDIX M - TZID/AZH POSITIONER
INTRODUCTION
This appendix covers the configuration, calibration and special fea-
ture functions of the TZID/AZH Positioner. Table M-1 lists the error
and problem codes of the TZID/AZH positioner.
Refer to OPERATING PROCEDURES in Section 4 for information on
the following functions:
CREATE/MODIFY CONFIGURATION
A configuration can be created off-line, without a connected field
device. Refer to Figure M-1 for an overview of the configuration
function. The following table details the configuration process.
• Send configurations. • Select configurations.
• Get configurations. • Erase configurations.
• View configurations. • Operational functions.
Figure M-1. Configuration Flowchart (TZID/AZH)
T02395A
DEVICE
TYPE
ENTER
DESCRIPTOR
CHARACTERISTIC
CURVE
ADJUST TIME
UP AND DOWN
CONFIGURATION
NAME
ENTER
DATE
ENTER
DEADBAND
VALUE
SAVE
CONFIGURATION
TAG
NUMBER
ENTER LOW
SET POINT
RANGE
ENTER
SHUT-OFF VALVE
PERCENTAGE
TRANSMITTER
TYPE
POSITIONING
TASK
SELECT
VALVE ACTION
ENTER
LOW AND HIGH
ALARM LIMITS
SELECT
MODE
SELECT
SET POINT
UNITS
ENTER
MIN AND MAX
STROKE VALUE
ENTER HIGH
SET POINT
RANGE
ENTER
DEADBAND
TIME LIMIT
C
O
N
F
I
G
U
R
E
To Next Page
Loading...
