INTRODUCTION
L - 1
APPENDIX L - TBN581 (ORP/pION) TRANSMITTER
INTRODUCTION
This appendix covers the configuration and calibration functions of
the TBN581 (ORP/pION) Transmitter.
Refer to OPERATING PROCEDURES in Section 4 for information on
the following functions:
NOTE: To change calibration or configuration parameters of a smart
field device that is connected to an IMFBS01 module, the device
must be taken off-line. This is done at the INFI 90 OPEN console.
CREATE/MODIFY CONFIGURATION
A configuration can be created off-line, without a connected field
device. Refer to Figure L-1 for an overview of the configuration
function. The following table details the configuration process.
• Send configurations. • Select configurations.
• Get configurations. • Erase configurations.
• View configurations. • Operational functions.
Figure L-1. Configuration Flowchart (TBN581)
T01335A
ENTER DAMPING
CONSTANT
ENTER LOWER
RANGE VALUE
ID TAG SELECT MODE
SELECT
TRANSMITTER
TYPE
SPECIFY
FUNCTION
GENERATOR
ENTER UPPER
RANGE VALUE
ENTER
CHANNEL
NUMBER
DIGITAL
ANALOG
SELECT
INITIALIZE MODE
SELECT FAIL
MODE
ENTER
SECONDARY
UNITS
ENTER
SECONDARY
LOWER/UPPER
RANGE VALUES
SAVE
CONFIGURATION
C
O
N
F
I
G
U
R
E
SELECT OUTPUT
ACTION
To Next Page
Loading...
