INTRODUCTION
J - 1
APPENDIX J - TBN480 CONDUCTIVITY TRANSMITTER
INTRODUCTION
This appendix covers the configuration and calibration functions of
the TBN480 Conductivity Transmitter.
Refer to OPERATING PROCEDURES in Section 4 for information on
the following functions:
NOTE: To change calibration or configuration parameters of a smart
field device that is connected to an IMFBS01 module, the device
must be taken off-line. This is done at the INFI 90 OPEN console.
CREATE/MODIFY CONFIGURATION
A configuration can be created off-line, without a connected field
device. Refer to Figure J-1 for an overview of the configuration
function. The following table details the configuration process.
• Send configurations. • Select configurations.
• Get configurations. • Erase configurations.
• View configurations. • Operational functions.
Figure J-1. Configuration Flowchart (TBN480)
T01339A
CHOOSE A
RANGE JUMPER
SELECT
SENSOR
GROUP
ID TAG SELECT MODE
DIGITAL
ANALOG
ENTER
CHANNEL
NUMBER
SELECT
TRANSMITTER
TYPE
SELECT
TEMPERATURE
COMPENSATION
EFFECT
SELECT DIAG
SPIKE NO/YES
ENTER
DAMPING
CONSTANT
SAVE
CONFIGURATION
SELECT
ANALYZER
TYPE
ENTER LOWER
RANGE VALUE
ENTER UPPER
RANGE VALUE
SELECT
INITIALIZE
MODE
SELECT FAIL
MODE
SELECT
TEMPERATURE
COMPENSATION
INPUT
C
O
N
F
I
G
U
R
E
To Next Page
Loading...
